SOI 04.05 FV 34/57 599 36 62-62
7. ERROR CODES
The electronic control system performs an internal autodiagnostics routine. If an operating malfunction is
detected, the corresponding error code is displayed.
To display the error codes, it is sufficient to touch the "clock" sensor and then select the inoperative burner. The
error code will be displayed automatically (see Fig. 39 and 40).
If the malfunction affects not one single burner but the entire hob, the same code will be displayed for each
burner.
Fig. 39
Fig. 40
To Next Page
Loading...
