SOI 04.05 FV 30/57 599 36 62-62
4. Select the desired cooking time by touching sensors
or .
After the cooking time has been entered, it is no
longer possible to change the burner selected.
To change burners, it is necessary to reset the
cooking time by touching sensor
, and then
changing the burner by touching sensor
.
5. A few moments after selection, the timer countdown
begins.
6. During the last ten seconds of the countdown, the timer
sounds a short buzz to warn the user that the
programmed cooking time is about to end.
7. At the end of the time entered, the buzzer sounds. Touch
sensor
to switch off the buzzer.
5.10.1.1 Modifying the programmed setting
1. At any time, touch sensors
or to increase or
decrease the time entered.
5.10.1.2 Resetting the minute-minder setting
1. Touch sensor
to reduce the time to zero.
Only one burner at a time can be programmed to
switch off automatically.
Fig. 25
The cooking time can be programmed with the
burner lit or off.
For example, after a saucepan of water has been
brought to the boil, then the cooking time for the
pasta or rice etc. can be entered.
The "residual heat" LEDs remain lit even after the
hob has been switched off, and until the grille and
the burner have cooled down.
To Next Page
Loading...
Need help?
General
