12
The pan is not in working
position.
The grid is fully or partially
open.
Overheating of the heating
element. In the event of a
fault in the element sensor,
the heat is switched off.
STOP has been pressed
during operation.
Overloaded agitator
Open-circuit in the PT-1000
sensor
Short-circuit in the PT-1000
sensor
Open-circuit in the PT-1000
sensor
Short-circuit in the PT-1000
sensor
Red LED in START flashing. The
following text appears in the display:
TILTING
Xh XXmin XXX°C
AGITATOR 000rpm
AGITATOR
GRID ON
Buzzer sounds and the following
text appears in the display:
ELEMENT
OVERHEATED
INTERRUPT?
YES PRESS STOP
NO PRESS START
The agitator has stopped
The following text appears in the
display:
OVERLOADED
SHUT-OFF BOILING PAN
DURING APPROX. 1 MIN
PT-1000 FOOD
INTERAPTION
PT-1000 FOOD
SHORT-CIRCUIT
PT-1000 ELEMENT
INTERAPTION
PT-1000 ELEMENT
SHORT-CIRCUIT
Messages and Error codes
Messages Cause Action
Press Tilt return .
Close the grid and press Agitator start .
• Press On/Off . The display goes out.
• Wait for 5 seconds!
• Press On/Off . The display is lit.
If the warning remains lit:
• Press On/Off to switch off the pan.
The display goes out.
See Warning! Overheating and contact author-
ised personnel.
Follow the instructions in the display.
• Press STOP to interrupt.
or
• Press START to go back to the program.
• Press On/Off
The display goes out.
Wait for approx. 1 minute
Increase the agitator speed
or
Reduce the amount of food in the pan
• Press On/Off . The display is lit.
Contact authorised personnel.
Contact authorised personnel.
Contact authorised personnel.
Contact authorised personnel.
Table 1
To Next Page
Loading...
Need help?
General
