Electrolux TT300 - Cooling Time and Moisture Level Settings; Extra Drying Time Parameters

Parameter programming
49
487 18 39 01 - 300/500/750 - GB
Program
P1 =
extra dry
Program
P2 =
ready to put away
Program
P1 =
extra dry
Extra drying
time
in minutes
Extra drying
time
in minutes
Program
P3 =
ironing dry
Extra drying
time
in minutes
Residual
moisture level,
F0 = ready
to put away
Program
P3 =
ironing dry
Residual
moisture level,
F0 = ready
to put away
Residual
moisture level,
e.g. 30 =
iron dry
Cooling time
Residual moisture level
The measurement of residual moisture level consists of a combined parameter set for residual
moisture + a parameter for extra drying time.
Extra drying time
Cooling time
Running time
without
heat at end of
cycle
Count down Count up
-- --
Can be set to a value
between 00 and 10 minutes.
Factory setting = 03
Can be set to a value
between 05 and F0.
Factory setting F0
Can be set to a value
between 05 and F0.
Factory setting F0
Can be set to a value
between 05 and F0.
Factory setting 30
Can be set to a value
between 00 and 20 minutes.
Factory setting 09
Can be set to a value
between 00 and 20 minutes.
Factory setting 03
Can be set to a value
between 00 and 20 minutes.
Factory setting 00
Extra drying time when the value set
in parameter 09 has been reached.
The values for residual moisture are
given in hexadecimals (05-F0). See
explanation on following page.
Extra drying time when the value set
in parameter 10 has been reached.
Extra drying time when the value set
in parameter 11 has been reached.
Parameter no.
check by pressing
the clock button
Value
can be set after two seconds
Required change:
Press the “count up/down” buttons.
Program
P2 =
ready to put away