Leveling
5.Click back to the "Manual" page, and click
the Z-axis "up" button to raise the Z-axis by
a certain distance. (about 100mm)
(See Picture 6)
6. Take away the leveling card, and click the "Tool" - "Exposure" - "Next" buttons to test the LCD
screen and LED light source. If the LCD can display "ELEGOO TECHNOLOGY www.elegoo.com",
then the 3D printer works perfectly. At this time, the leveling is completed, install the resin tank
and ready for printing. (See Picture 7)
(Picture 6)
校正
(Picture 7)
To Next Page
Loading...
