Elegoo MARS 4 - Leveling

2. Place a leveling card between the build plate and the LCD screen, then click "Move Z axis to zero"
(See Picture 2). After the printer stops moving, press the top of the build plate with one hand, and
lock the fixing screws ( ) with the other hand. (See Picture 3)
1. Remove the resin tank, lock the screw knob
( ) of the build plate, and then loosen the 2
fixing screws ( ) of the build plate until
the build plate can move freely. (See Picture 1)
Leveling
(Picture 1)
(Picture 2) (Picture 3)
A4 Paper
A4 Paper