123
Page
Check appliance for correct flame operation,
Check pilot flame, Check main burner is not smothered
and flames are even along burner with correct colour
and not excessively yellow or sooty. (Note it takes upto
10minutes of operation for the flame to achieve full colour.)
Remove manometer and tighten test point. Check test
point for gas leaks.
Turn appliance off.
Refit lower access panel.
Refit trim.
Refit trim retaining screws (2 off) Screws locate into 2 off
pre-threaded holes in the appliance casing.
Burner pressure
test point
Max pressure
adjustment nut
Min pressure
adjustment screw
To Next Page
Loading...