DIP-SWITCH 8 enables automatic switching of the motors.
In OFF position, G/P1 input directly and independently controls motor output 1 and G/P2 directly
and independently controls motor output 2.
In the ON position, this function means that on each call from G/P1 the motor outputs are
activated alternately and, in the event of a simultaneous call from G/P2 input , both motors will
be operated. When enabled, the switching module alternates the motor on each call from G/P1
input and also switches motors in the event of:
• Current overload of a motor
• Motor set to standby
• Lack of water on subsequent automatic reset
To Next Page
Loading...
