§ Select Access control (confirm with „ ” )
§ Select Firmware Version (confirm with „ ” )
Version number is displayed. To terminate the number displaying press „#”.
5.2 Access control
5.2.1 Service Code
allows changing the fitter code (8 digits), after previous entering current code,
Administrator (fitter) service code is provided by the manufacturer. To increase the safety and comfort of
administrator, it is recommended to change the code after initial start-up. To change the service code:
§ Enter the menu Settings ( code )
§ Select Service programs (confirm with „ ”)
§ Select Access control (confirm with „ ” )
§ Select Service code (confirm with „ ” )
then:
§ Enter the code confirm with „ ”,
§ Enter new code and confirm with „ ” (new code must have eight digits).
§ Confirm new code by re-entering it and confirm with „ ” ,
§ When "SAVE?" message appears, confirm with „ ” ,
!
Factory service code always starts with four digit prefix 1131. To provide compatibility, it is
recommended that the new code maintains the prefix.
5.2.2 Service RFID tags
12
allows editing (adding and deleting) fitter tags,
The service RFID tag allows editing the settings (allows entering the full menu Settings – see clause 5)
without using the administrator code (RFID tag becomes additional code). Service tags can be added or
deleted. Number of service RFID tags is max. 8.
To add the service tag:
§ Enter the menu Settings ( code )
§ Select Service programs (confirm with „ ”)
§ Select Access control (confirm with „ ” )
§ Select Service RF tags (confirm with „ ” )
§ Using arrows (keys "0", "8"), select tag number,
§ Approach new tag near the reader module until message "ADD as X TAG" appears, where X stands
for tag number,
§ Confirm with „ ” , or cancel with „#”
To delete the service tag:
§ Enter the menu Settings ( code )
12
Applies to Optima SL255R, Optima SL255RC
28
To Next Page
Loading...