RF tag usage conformation
Entry code usage conformation
Wrong code usage confirmation
5.6.4 Entry code
Enable / disable edition by users of their individual access codes.
5.6.5 RF tags
21
Enable / disable edition by users of their individual RF tags.
5.6.6 Turn off handset
Enable / disable edition by users of the handset turn off option.
5.6.7 Activate office mode
Enable / disable edition by users of the office mode option.
5.6.8 Enable all
Enables edition of all parameters by users.
5.6.9 Disable all
Disables the user option to edit all settings. If disabled all, upon attempt to enter user menu, the following
message should appear "NOT AVAILABLE”.
6 . Operation in multi-entry system
22
Digital panels OPTIMA SL255 are adapted to operate in multi-entry system. It is possible to extend the
system to operate maximum 4 entries. Handset line is connected in parallel to LU and GND terminals of
each panel. The panels communicate with each other using IS data transmission line. In case of two-entry
system, this is a direct communication, but where the system operates more than 2 panels, communication
takes place using communication module OP-H4MS. Thecommunication module OP-H4MS is necessary
because of the number of panels in each multi-entry system, where other devices connected to IS bus are
applied - electronic tenants list OP-EL, single-button list OP-J4. Similarly, in each multi-entry video system
(using Optima SL255RC panel), the communication module OP-H4MS is a necessary system element.
21
Applies to Optima SL255R, Optima SL255RC
22
Applies to Optima SL255R, Optima SL255RC
46
To Next Page
Loading...