CONDITIONS OF USE
Permitted Use
For safety reasons the instrument must be installed and used according to the instruction provided and in particular,
under normal conditions, parts bearing dangerous voltage levels must not be accessible. The device must be adequately
protected from water and dust as per the application and must also only be accessible via the use of tools (with the
exception of the frontlet).
The device is ideally suited for use on household appliances and/or similar refrigeration equipment and has been tested
with regard to the aspects concerning European reference standards on safety. It is classified as follows:
• according to its manufacture: as an automatic electronic control device to be incorporated by independent mounting;
• according to its automatic operating features: as a 1 B-type operated control type;
• as a Class A device in relation to the category and structure of the software.
Unpermitted use
Any other use other than that permitted is de facto prohibited. It should be noted that the relay contacts provided are
of a practical type and therefore subject to fault. Any protection devices required by product standards or dictated by
common sense due to obvious safety reasons should be applied externally.
LIABILITY AND RESIDUAL RISKS
ELIWELL CONTROLS SRL shall not be liable for any damages deriving from:
- installation/use other than that prescribed and, in particular, that which does not comply with safety standards
anticipated by regulations and/or those given herein;
- use on boards which do not guarantee adequate protection against electric shock, water or dust under the conditions
of assembly applied;
- use on boards which allow access to dangerous parts without the use of tools;
- tampering with and/or alteration of the products;
- installation/use on boards that do not comply with the standards and regulations in force.
13
To Next Page
Loading...
Need help?
General
