Smart ZB Thermostat 16 A
Confirming the preset
Select the preset that meets your needs using the +/- buttons, and then hold the O
for > 1 s to confirm the selection.
For example, P1 is confirmed.
• Cycle Time : 20 mins
• Valve Protection : Off
If the preset value of P6, P7 or P8 is set and the thermostat is connected with an
external floor sensor then you need to set the sensor type. Refer manual sensor
settings, page 10.
NOTE: After configuring the thermostat, if you want to change or modify the
preset or sensor setting, press O and + button simultaneously to enter preset
selection and continue the process.
DUG_ZB Thermostat 16 A_ELKO-00 9
To Next Page
Loading...