22 FAP User
18.6 APPENDIX 6 – SYSTEM ERROR CODES
A system error is notified to the user with the following message:
FAULT SYSTEM ERROR (XX)
XX = error code
The following table reports the error codes along with the relevant explanation:
Code Fault
1 Internal memory error (stack of exclusions) (1)
2 Internal memory error (stack of zone alarms) (1)
3 Internal memory error (stack of general faults) (1)
4 Internal memory error (stack of field faults) (1)
5 Internal memory error (stack of maintenance events) (1)
6 Internal memory error (FIFO of alarms) (1)
7 Internal memory error (stack of slave panels events) (1)
8 Internal memory error (stack of alarms of groups of points) (1)
9 Internal memory error (stack of alarms of groups of zones) (1)
10 Attempt to include an element already included
11 Internal memory error (stack of a task of the operating system *) (1)
12 Program supervision error (**) (1)
13 Data memory integrity check (according to EN54) failed (1)
14 Program memory integrity check (according to EN54) failed
15 Access error to the external flash memory
16 Fault on trasmitter for communication with internal modules
17 Fault on transmitter for communication with the modem
18 Fault on transmitter for communication with remote LCD annunciators and printer module
19 Fault on transmitter for Master/Slave communication
20 Display blocked
21 Control panel reset caused by the program supervisor (1)
22 Control panel reset caused by low supply voltage
23 Not used
24 Fault on transmitter for LAN communication
25 Startup up error of TCP server application (***)
26 Not used
27 LAN cable removed
28 Modem phone line integrity check failed
29 Internal memory error (stack of generic events) (1)
30 External USB card faulty
31 Battery voltage check during temperature variation failed
(*) This fault is characterized by another parameter, indicating the task affected by the stack overflow:
FAULT SYSTEM ERROR (11) XX
XX = identifier of the task whose stack has been affected by the overflow
(**) When this fault occurs, one further event is stored in the event log. This event contains the supervision mask
of the tasks, containing the information on the tasks blocked:
FAULT SYSTEM ERROR (12)
FW MASK BMP3 BMP2 BMP1 BMP0
BMP3, BMP2, BMP1, BMP0 = bitmap of the supervision mask (32 bit)
(***) This fault occurs when the Ethernet configuration parameters are wrong. To solve this issue, reconfigure
these parameters from the relevant programming menu.
(1) Please, contact the ELKRON Customer Service.
To Next Page
Loading...
