18 FAP User
18 APPENDIX
18.1 APPENDIX 1 – ERROR CODES FOR FAULT OF POINTS
If a point undergoes a fault, this fault is detected by the control panel during the scanning phase and the user is
notified about it with a message:
FAULT ZXXX CYY PZZZ TT FWWW
NAME OF THE POINT
XXX = number of the zone which the point belongs to
YY = circuit which the point is connected to
ZZZ = address of the point
TT = type (in short) of the point
WWW = fault code
If the point is an output module, the user is notified about the fault with one of the following messages, depending on
the fault:
FAULT EXT. CXX PYYY OM FZZZ
NAME OF THE MODULE
or:
FAULT CXX PYYY OM FZZZ
NAME OF THE MODULE
XX = circuit which the module is connected to
YYY = address of the module
ZZZ = fault code
To Next Page
Loading...
