elmeg IP630 / en / elmeg IP630 / web_configurator.fm / 8/24/16
Template bintec-elmeg, Version 1, 01.07.2014
33
elmeg IP630
bintec elmeg Configuring other settings with the Web configurator
Telephony
Changing the standard send connection
If the telephone has more than one VoIP connection, outgoing calls are initiated via the stand-
ard send connection ( page 13).
Changing the standard send connection:
¤ Settings Te lep hony Connections
All the configured connections are shown. The check box under Default send connection
shows which connection is currently selected.
¤ Check the connection required Set
Only active connections can be selected.
Settings for Call Waiting
Specify the telephone's response when another call comes in during a call.
¤ Settings Te lep hony Call Settings
For each connection:
Prevent/permit Call Waiting:
¤ Select the option under Display waiting call ( = Call Waiting permitted) /
deselect ( = Call Waiting not permitted)
Permit Call Waiting:
¤ Select Acoustic signal from the list
Off: the incoming call is shown in the display only
or signalling with a Call Waiting tone (beep): once or every 4, 10, or 20 seconds
Save the settings: Set
To Next Page
Loading...