74
English
TROUBLE
SHOOTING
4.
TROUBLE SHOOTING
4
4-1 Symptoms and Confirmation
Check the following items. If any abnormality is found, consult the dealer from
whom you purchased this product or our nearest branch/office.
Symptom Possible cause/remedy
No image is
displayed.
• The cable is not correctly connected.
• The AC adapter is disconnected from the wall outlet.
• The AC adapter is disconnected from the power supply
socket of the unit.
• The power is not ON. (Blue light)
• Zoom is set at the TELE side, displaying only the white/
black part of the document.
• If you turn the power ON immediately after turning it OFF,
the unit may not start. Wait for several seconds after
turning the power OFF, and then turn it back ON.
• The slide switch is not set to the correct image output
(RGB/HDMI/VIDEO). Set the "RGB/HDMI/VIDEO Switch"
correctly.
P.10
• Reconnect the AC adapter.
The output image
(resolution) changes
automatically.
• When the HDMI monitor is connected, the output
image (resolution) is automatically changed based on
information from the connected monitor.
No image is
displayed from the
USB.
• No image is output from USB, when USB mode is set to
mass Storage or in Play mode. Switch the USB mode
from Mass Storage to Application by referring to the
"Function Setting Menu". When using Play mode, change
the output image to Camera image.
The image is out of
focus.
• The document (object) is too close to the lens. Move the
document (object) slightly away from the lens.
• Auto focus may have difficulty in adjusting correctly.
Focus on an image manually by referring to "Manual
focus".
The video output
image is scrambled
or unclear.
• Video output is set to [NTSC]. If this product is set to
the NTSC system and connected to a monitor specially
designed for the PAL system, the video image may not
be normally output but be scrambled or be displayed in
black and white. Set the video output system to PAL.
To Next Page
Loading...
Need help?
General
