73
SECTION VII
Programming Combinations (Must have
3 Digit Mode Activated)
Single Repeat with Memory Auto-Lock
z Select 081.
Machine automatically converts to show selected
stitch image and information after third digit is
pressed.
x Press “Mirror Image” key.
c Press “Elongation” key.
v Press “Stitch Length” key and change stitch length
to 0.30.
b Press “ENTER” key to memorize. A blinking
cursor will appear to indicate where next selected
and entered stitch will be memorized within the
sequence.
n Press “Memory Auto-Lock” key.
NOTE: It is not possible to add a stitch at the end
of a sequence following the memory auto-lock
stitch.
m Press “Memory Auto Thread Cut” key. (The
Auto Thread Cut LED signal light turns on.)
, Place fabric and stabilizer under foot and sew.
Machine will complete the design, lockstitch, cut
threads and automatically stop.
z
x
c
v
b
n
m
,
To Next Page
Loading...
