83
Changing the Light Bulb
Tur n OFF the power switch. Unplug the machine.
Wait until the bulb has cooled before touching it.
Remove screw q. Pull away face plate w.
Swing light socket e to left and pull out light bulb
r.
Insert light bulb into light socket. Return light
socket to original position.
Replace face plate and tighten screw.
NOTE: Only use same type light bulb rated 12 Volts,
5 watts.
q
w
e
r
e
w
q
Replacing the Bobbin Case
Insert the bobbin case so the knob q fits next to
the stopper w in the hook area. The red triangle
marks e on the bobbin case and stopper must
align with each other.
Attach the needle plate and tighten the screws.
After cleaning, be sure to replace the needle,
presser foot and bobbin.
To Next Page
Loading...
