- 1 -
REGULATORY INFORMATION
1. Electrical Safety Information
1.1 Compliance is required with respect to the voltage, frequency, and current
requirements indicated on the manufacturer’ s label. Connection to a different
power source than those specified herein will likely result in improper operation or
damage to the equipment, or may pose a fire hazard if the limitations are exceeded.
1.2 There are no operator serviceable parts inside this equipment. This equipment
generates hazardous voltages that constitute a safety hazard. Service should be
provided only by a qualified service technician.
1.3 This equipment is provided with a detachable power cord that has an integral
safety ground wire and three-prong connector intended for connection to a
grounded safety outlet.
1.3.1 Do not substitute the cord with any cord other than the provided approved
type. Under no circumstances use an adapter plug to connect to a two-wire
outlet, as this will defeat the continuity of the grounding wire.
1.3.2 This equipment requires the use of the ground wire as a part of its safety
certification. Modification or misuse can provide a shock hazard that can
result in serious injury or death.
1.3.3 If there are any questions about the installation prior to connecting the
equipment to mains power, contact a qualified electrician or the manufacturer.
2. Emissions and Immunity Information
2.1 Notice to Users in the United States: This equipment has been tested and found to
comply with Part 15 Class B of FCC Rules for digital devices. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses , and can radiate radio frequency energy,
and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
2.2 Notice to Users in Canada: This equipment has been tested and found to comply with
Class B radio noise emission limits as established by the Radio Interference Regulations
of Industries Canada for digital devices.
2.3 Notice to Users in the European Union: This equipment has been tested and found to
comply with the Class B requirements of CE marking for Information Technology
Equipment as require by :Low Voltage Directive 73/23/ECC and standard EN 60950 ;
EMC Directive 89/336/ECC, and per standard EN 55022.
2.4 General Information to All Users: This equipment generates, uses , and can radiate
radio frequency energy. If not installed nad used according to this manual, the
equipment may cause interference with radio and television communications. There is ,
however, no guarantee that interference will not occur in any particular installation due
to site-specific factors.
2.4.1 In order to meet emission and immunity requirements, the user must observe the
following:
2.4.1.1 Use only the provided I/O cables to connect this digital device with any
To Next Page
Loading...
Need help?
General
