3. Transport and storage EN
12.7.23 V2.1 9 / 24
2.3 Conformity
The product Safety evaluation unit conforms to the state of the art plus the
applicable safety conditions at the time of bringing into circulation within the
scope of its intended use. From a design point of view, foreseeable misuse
cannot be avoided without limiting the intended functionality.
Ensure that all applicable European directives and national laws/directives
are observed. The declaration of conformity can be found in the Appendix
under 8. EU Declaration of Conformity, page 23.
2.4 Changes, modification measures
Any unauthorised change or conversion is expressly forbidden.
2.5 Warning against misuse
In case of incorrect or unintended use or manipulation, the use of the safety
evaluation unit does not exclude risks to persons or damage to machine
and/or system components.
• Please observe the information stipulated in ISO 14119.
• Make sure that no current or voltage peaks that are higher than the elec-
trical specifications of the safety evaluation unit are caused by any exter-
nal components. Current or voltage peaks are produced, for example, by
capacitive or inductive loads.
• Exceeding the electrical specifications of the safety evaluation unit (e.g.
in the event of defective wiring or short circuits) can damage the system
irreparably. Non-compliance can result in reduced service life.
3. Transport and storage
During transport and storage, protect the product against heat, moisture,
chemicals and impacts. Do not exceed the permissible storage temperature
of -25°C to +70°C.
More information on the ambient conditions can be found in chapter 4. Pro-
duct-specific information, page 10.
To Next Page
Loading...
