Contents
man_905-105_2.16 Page 3
FCC Notice: 905U Wireless I/O Module
This user’s manual is for the ELPRO 905U wireless I/O module. This device complies with Part
15.247 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference and
2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment is suitable for use in Class I Division 2 groups A, B C and D or non-hazardous
locations only
This device must be operated as supplied by ELPRO Technologies. Any changes or modifications
made to the device without the written consent of ELPRO Technologies may void the user’s authority
to operate the device.
End user products that have this device embedded must be installed by experienced radio and antenna
personnel, or supplied with non-standard antenna connectors, and antennas available from vendors
specified by ELPRO Technologies. Please contact ELPRO Technologies for end user antenna and
connector recommendations.
Notices: Safety
Exposure to RF energy is an important safety consideration. The FCC has adopted a safety standard for
human exposure to radio frequency electromagnetic energy emitted by FCC regulated equipment as a
result of its actions in Docket 93-62 and OET Bulletin 65 Edition 97-01.
FCC Notice: 105U Wireless I/O Module
Part 15 – This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part15 of the FCC rules (Code of Federal Regulations 47CFR Part 15).
Operation is subject to the condition that this device does not cause harmful interference.
Part 90 – This device has been type accepted for operation by the FCC in accordance with Part90 of
the FCC rules (47CFR Part 90). See the label on the unit for the specific FCC ID and any
other certification designations.
Industry Canada: 105U Wireless I/O Module
RSS-119 - This device has been type accepted for operation by Industry Canada in accordance with
RSS-119 of the Industry Canada rules. See the label on the unit for the specific Industry
Canada certification number and any other certification designations.
Notice Any changes or modifications not expressly approved by ELPRO Technologies P/L could
void the user’s authority to operate this equipment.
To operate this equipment legally the user must obtain a radio operating license from the
government agency. This is done so the government can coordinate radio users in order to
minimize interference.
To Next Page
Loading...
