04
REMOTE CONTROL
Installation of batteries
Remove the cover as illustrated.
Insert two batteries of the type
AAA/R03/UM4. Make sure that the
terminals correspond to the symbols
shown (see bottom).
Replace the cover.
Do not mix new and old batteries, and do not use different types of batteries.
If the remote control is not used for prolonged periods, remove the batteries from the remote control
to prevent corrosion.
Using the remote control
Aim the remote control at the sensor on the receiver's
front panel. When the remote control signal is
received, the receiver will respond accordingly. The
remote control works within a range of about 6m.
Do not expose the unit to strong sources of light. This may disable the use of the remote control.
Do not use other remote controls near the unit. This may cause a malfunction.
Do not place any objects on the remote control as the batteries may be discharged if a key is depressed
continuously.
Do not place large objects between the remote control and the receiver.
Do not place the receiver behind tinted glass. This will reduce the range of the remote control.
AVR-280 HOME THEATRE RECEIVER
R
MODE
DSP
INPUT BALANCE
TUNING
BAND
VOLUME/TUNING
POWER
Infrared-
Sensor
STANDBY
MUTE
AVR-280
VOLUME
TUNING +
COAX
DIGITAL DVD/SAT
AUX 1
AUX 2
TUNER
RDS
TV
R
MEMORY
DELAY
DSP
MODE
SPK
MODE
MODE
TEST
BASS
BOOST
BALANCE
NIGHT
DELAY
++++
-
-
MONO
BAND
CENTER
REAR
OPT
AUTO
MANUAL
PR +
PR -
TUNING -
To Next Page
Loading...
Need help?
General
