Primary Switch Mode Rectifier
PSS30
User manual
Page 2 (28)
Eltek Valere Industrial ©2008 UM_PSS30_E_R00
Notes to this manual
ATTENTION! Read this manual before installing and commissioning the specified module.
This manual is a part of the delivered module. Familiarity with the contents of this manual is required
for installing and operating the specified module.
The function description in this manual corresponds to the stage of technology at the date of
publishing. Technical changes and changes in form and content can be made at any time by the
manufacturer without notice. There are no obligations to update the manual continually.
The rules for prevention of accidents for the specific country and the general safety rules in
accordance with IEC 364 must be observed.
The module is manufactured in accordance with applicable DIN and VDE standards such as VDE 0106
(part 100) and VDE 0100 (part 410). The CE marking on the module confirms compliance with EU
standards 73/23 EWG (low voltage) and 89/339 EWG (electromagnetic compatibility) if the installation
and operation instructions are followed.
Supplier:
ELTEK VALERE INDUSTRIAL GmbH
Schillerstraße 16
D-32052 Herford
+ 49 (0) 5221 1708-210
FAX + 49 (0) 5221 1708-222
Email Info.industrial@eltekvalere.com
Internet http://www.eltekvalere-industrial.com
© Copyright ELTEK VALERE INDUSTRIAL 2008. All rights reserved.
NOTE: Repetition, copying and /or taking possession of this user manual, even in extracts, with
electronic or mechanical means, requires the written prior permission of the manufacturer.