Primary Switch Mode Rectifier
PSS30
User manual
Page 5 (28)
Eltek Valere Industrial ©2008 UM_PSS30_E_R00
Safety instructions and waste disposal rules
Warning!
Because several components of operating electrical modules are charged by dangerous voltage, the
improper handling of electrical modules may be the cause of accidents involving electrocution, injury,
or material damages.
• Operation and maintenance of electrical modules must be performed by qualified skilled
personnel such as electricians in accordance with EN 50110-1 or IEC 60950.
• Install the module only in areas with limited access to unskilled personnel.
• Before starting work, the electrical module must be disconnected from mains. Make sure that
the module is earthed.
• Do not touch connector pins as they can be charged with dangerous voltage up to 30 seconds
after disconnection.
• Only spare parts approved by the manufacturer must be used.
All electric modules must be disposed of separate from domestic waste at collecting points that
have been set up by the government or municipal authority.
“Separate collection is the precondition to ensure specific treatment and recycling of WEEE and is
necessary to achieve the chosen level of protection of human health and the environment in the
Community.”
The above statement from EU directive 2002/96/EC applies to all electric modules installed within
EU countries.
In countries outside the EU, different rules may apply regarding waste disposal of electric modules.
For more information about waste disposal of your discarded equipment, contact your
ELTEK VALERE INDUSTRIAL partner.
To Next Page
Loading...
Need help?
General