ELTEX KNH35 - 4.2 Menu system

24 BA-en-3031-2004_KNH35
4.2 Menu system
The menu system allows all settings to be changed. The key assignment
differs from the main view.
Function of the operator keys in the menu system
Caution!
If no key is activated in the menu or during editing for longer than 10 s, the
system will return automatically to the main display. This return action has
the same effect as an escape, i.e. the changes will not be saved.
Display
The menu name (in capital letters) is shown centered in the top line. The
currently active menu entry is shown in the bottom line.
Use the <7> key to abort editing.
In the menu system the display also skips back one
menu level. Holding the key down for longer than
2 seconds will return the display to the main display.
Use the <3> key to save the new value and to end
editing.
Select a menu entry in the menu system or open the
appropriate sub-menu.
In the menu system, the <
 > key only has switch-off
function.
If the key is pressed, all activated high voltage outputs
will be switched off.
Use the arrow keys <> <> to navigate through the
menus.
If a certain value is edited, each strike of the key will
result in a change in the setting. Numerical values are
incremented / decreased in 1-digit steps with each key
strike. If the key is held down, changes are made in
10-digit increments.
MAIN MENU
setpoint
menu name
menu entry