ELTEX NTU-RG-1402G-W - Voice Menu: SIP Settings; SIP Basic Setting Submenu: Common SIP Settings

____________________________________________________________________________________
____________________________________________________________________________________
NTU Optical Network Terminals 51
Configure NAT on an active WAN interface to use UPnP.
Set the Enable UPnP to enable UPnP.
To accept and save settings, click the Apply/Save button.
4.3 Voice menu. SIP settings
1
4.3.1 SIP Basic Setting submenu. Common SIP settings
— Local selection – location selection;
— SIP domain name – SIP domine name;
— VoIP Dialpan Setting – dialplan configuration (recommended to use 'x.T')
— Use SIP Proxy – when checked SIP Proxy is used:
— SIP Proxy – SIP Proxy address;
— SIP Proxy port – SIP Proxy port;
— Use SIP Outbound Proxy – when checked, use SIP Outbound-proxy to transmit all requests otherwise SIP
Outbound-proxy is not used:
— SIP Outbound Proxy – SIP proxy address which will be used to transfer all requests (this
server will be used for routing SIP Proxy and SIP Registrar);
1
SIP settings are available for NTU-2V(C) and NTU-RG-1402G-W only. If this menu is absence in the configurator it
means settings have already been completed by your service provider.