ELTEX NTU-RG-1402G-W - The Wireless Bridge Submenu. Configuration of Wireless Connection in the Bridge Mode; The Advanced Submenu. Advanced Settings

____________________________________________________________________________________
____________________________________________________________________________________
58 NTU Optical Network Terminals
– Deny—filter by denied addresses.
To add a MAC address into the filter table, click the Add button and enter its value into the MAC address
field in the displayed menu:
Click the Apply/Save button to accept the changes.
4.4.4 The Wireless Bridge Submenu. Configuration of Wireless Connection in the Bridge Mode
The menu specifies an operation mode of access point: either access point or wireless bridge.
Using the bridge mode requires MAC addresses of remote bridges to be specified. The mode is used for
wireless connection between two independent networks.
The Wireless Bridge mode has the following settings:
– Bridge Restrict—select a bridge operation mode:
– Enabled—enable the MAC address filter (allowed are only the specified addresses);
– Enable (Scan)—search for remote bridges;
– Disable—no restrictions for MAC addresses;
– Remote Bridges MAC Address—addresses of remote bridges.
The router doesn't support the Wi-Fi Multimedia (WMM) function in the bridge mode.
Click Refresh to update information on available remote bridges.
Click the Apply/Save button to accept and save the changes.
4.4.5 The Advanced Submenu. Advanced Settings
The menu allows advanced configuration of wireless network.