ELTEX NTU-RG-1402G-W - Wireless Menu: Wi-Fi Network Setup; Basic Submenu: General Information

____________________________________________________________________________________
____________________________________________________________________________________
NTU Optical Network Terminals 53
— Call barring mode – call barring mode;
— Call barring pin – password for outgoing calls;
— Call barring digit map – digit map which allows/bars outgoing calls;
— Warm line – when checked, ‘Warm Line’ service is enabled, otherwise the service is disabled. The service
allows you to establish an outgoing connection automatically without dialing the number right after the
lifting of a headset (‘hot line)’, or with delay (‘warm line’);
— Warm line number – warm line number;
— Warm line timeout – a delay before warm line dialing;
— Anonymous call blocking – when checked, blocking of calls from subscribers whose numbers were not
indentified is enabled;
— Anonymous calling – when checked, calls from port number are not indentified (Caller Identity
Restriction service);
— DND – when checked, ‘Do Not Disturb’ service is enabled.
To accept and save the settings, click the Apply/Save button.
To apply the new settings, stop SIP client by clicking Stop SIP client button and start SIP client again by
clicking Start SIP client button.
4.4 The Wireless Menu
1
. Wi-Fi Network Setup
4.4.1 The Basic submenu. General information
This menu is used for general setup of the LAN wireless interface and allows users to specify up to three
wireless access points.
– Enable Wireless—enable Wi-Fi on the device;
– Hide Access Point—hidden operation mode of the access point (in this mode, the router does not
broadcast wireless network SSID);
– Clients Isolation—when checked, disables interaction between wireless clients;
– Disable WMM Advertise—disable WMM (Wi-Fi Multimedia—QoS for wireless networks);
– Enable Wireless Multicast Forwarding (WMF)—enables wireless multicast forwarding (WMF);
1
Only for NTU-2W, NTU-RG-1402G-W