ELTEX TAU-8.IP - Network Interface Monitoring

101 VoIP Subscriber Gateways
To stop update, click ‘Stop update’ button.
To restore auto refresh, select ‘Interval’ (3-59 seconds) and click ‘Auto refresh’ button.
To view information of ‘Process status’ table fields click ‘See the most used signal descriptions’
button.
3.2.3 The ‘Interfaces’ submenu
Use the menu to monitoring such external network parameters of interfaces as IP address,
number of received and transmitted packets. For TAU-8.IP-W is available monitoring of Wi-Fi
parameters.
The following information about active services will be displayed in the table:
- Bridge mode – you can check enabled or disabled bridge mode in the service;
- WAN IP – IP address of the service WAN interface (when bridge mode is enabled, you
can see IP address specified to the bridge);
- WLAN IP – WLAN status (enabled/disabled);
- WAN Traffic, b – shows received and transmitted traffic through WAN interface;
Wi-Fi information is displayed for TAU-8.IP:
- Wi-Fi Status – shows current status of wireless network for this service:
 Error of address getting – Wi-Fi configuration file is not read or PC board is not
checked for Wi-Fi;
 Disabled – Wi-Fi is disabled in configuration;
 Enabled – Wi-Fi is enabled and active;
 Error of initialization – Wi-Fi is disabled in configuration but is not active because of
error;
 Unknown – status is not known;