55 VoIP Subscriber Gateways
When the printer is connected to the USB port, it should be determined automatically. To
configure printer, specify gateway path to the ppd file with detailed information about printer
functionality. You may find this ppd file in the web site of printer vendor.
Printer configuration in Windows:
The following steps are required to configure printer in Windows:
Go to ‘Start menu -> ‘Printers and faxes’ and select ‘Installation of new printer’ ->
Network printer or printer connected to another PC’ -> ‘Connect to a printer via
Internet, home network or intranet’ and enter the URL:
http://server:631/printers/model
In address, ‘Model’ parameter should be identical to printer name that is displayed on the
print page of print server.
Select preferred driver by using installation disk.
Installation is finished.
Advanced printer settings menu can be accessed by clicking the corresponding button.
On the page of advanced settings, printers can be combined into groups, control tasks, change
printer settings and print text pages. All the necessary information and help with print server settings
may be found on the www.cups.org web site.
To record changes into the non-volatile memory, click ‘Apply’ button.
2.4 The ‘PBX’ menu
Use ‘PBX’ menu to configure VoIP (Voice over IP): SIP protocol configuration, QoS (Quality of
Service) settings, FXS interface configuration, acoustic signal setting of line, setting of call groups and
groups of call intercepting, installation of codecs and dial plan.
2.4.1 The ‘SIP’ submenu
Use the menu to configure the device for operation via SIP protocol.
SIP (Session Initiation Protocol) is a signaling protocol used in VoIP. It performs basic call
management tasks such as starting and finishing session.
To Next Page
Loading...
