ELTEX TAU-8.IP - The SNMP Submenu

53 VoIP Subscriber Gateways
2.2.5 The ‘SNMP’ submenu
Terminal software allows you to monitor status of the device and its detectors, configure and
read some settings by using SNMP. In ‘SNMP’ menu, you can configure settings of SNMP agent. The
device supports SNMPv1 and SNMPv2 protocol version.
SNMP settings:
- Enable SNMP – when checked, SNMP will be enabled for utilization;
- Password on reading (roCommunity) – password for parameter reading (common:
public);
- Password on recording (rwCommunity) – password for parameter writing (common:
private);
- TrapSink – IP address of SNMPv1-trap message recipient in the format HOST
[COMMUNITY [PORT]];
- Trap2Sink – IP address SNMPv2-trap message recipient in the format HOST
[COMMUNITY [PORT]];
- Inform(InformSink) (address for receiving of messages) – IP address of Inform message
recipient in the format HOST [COMMUNITY [PORT]];
- Sys Name – device name;
- Sys Contact – contact details of the device vendor;