ELTEX TAU-8.IP - TAU Gateway Command Line Interface (CLI) Guide

130 VoIP Subscriber Gateways
APPENDIX C. THE USE OF COMMAND LINE INTERFACE (CLI) FOR CONFIGURATION AND MONITORING
Configuration changes, performed by CLI, will be applied after device reboot (except for IPTV settings). To apply changes, restart PBX (pbx restart). All the
current calls will be dropped.
To save changes into the device non-volatile memory, execute the save command.
CLI has two modes:
 privileged — available for 'admin' profile. The mode allows you to get full access to the device configuring, trouble-shooting and monitoring;
 unprivileged – available for 'admin' and 'user' profiles. The mode provides narrow set of the options for the device monitoring and trouble-shooting.
Table C.1 — CLI commands
Command
Value
Privilegy
Description
No command function
quit
-
none
Completes the
current CLI session
-
help
-
none
Displays CLI
command prompts
-
ping
<options>
<value>
IP address
none
-
repeat
<value>
int:1-4294967295
none
The number of
outgoing icmp echo
requests (default: 5)
5)
-
payload
<value>
int:0-65535
none
Size of data block (in
bytes) transmitted
by one icmp packets
as payload data
(default:56)
-
df-bit
-
none
don't fragment bit
setting (default: not
set)
-