ELTEX TAU-8.IP - Page 26

26 VoIP Subscriber Gateways
 Firmware only – provides only firmware autoupdate.
- Priority from – priority selection of file determination for autoprovisioning:
 DHCP options – when this priority is selected, URL of configuration file and
firmware are determined by using 43, 66 and 67 DHCP-options for that purpose
one of the services should have address getting configured via DHCP.
If you couldn’t eject autoupdate parameters the following URL parameters will be used
by default:
tftp://update.local/<MAC>.cfg - URL of the configuration file (where <MAC> is MAC-
address of the device, and symbol ‘.’ is byte-separator)
tftp://update.local/tau8.fw is URL of firmware file.
 Configuration update interval, sec – determinates configuration update interval. 0
value means that update will be applied only once when the device is launched;
 Firmware update interval, sec – determinates firmware update interval. 0 value
means update will be applied only once during the device start.
 Static settings – when this priority is selected, you should specify file location to
update configuration and firmware;
If the path to a file is absent, the following values will be used by default:
tftp://update.local/tau8.cfg - URL of configuration file;
tftp://update.local/tau8.fw- URL of firmware file.
 Configuration file – full configuration pathname in the URL format (TFTP-, HTTP-,
HTTPS- and FTP-URLs are supported, for example, tftp://update-
server.loc/tau8.conf);
 Firmware update interval, sec – determines configuration update interval. 0 value
means that update will be applied only once when the device is launched;
 Firmware file – pathname of firmware in the URL format (TFTP-, HTTP-, HTTPS-
and FTP-URLs are supported, for example, tftp://update-server.loc/tau8.conf);
 Configuration update interval, sec – determines firmware update interval. 0 value
means update will be applied only once during the device start.
See a detailed description of DHCP-based autoprovisioning operation algorithm in the section 5.
TR-069 Configuration:
- Enable TR-069 client – when checked, integrated TR-069 protocol client will be enabled;
- ACS URL – autoconfiguration server address. Enter address in the following format:
http://x.x.x.x:10301 (х.х.х.х – ACS server IP-address or domain name, 10301 – ACS server
port by default);