IT
26
40540 - 40542 - 40540.D - 40547
Programming the self-start push button to a specific entrance panel (excluding the lock release
button)
1. In the case of a handset entryphone, raise the handset and bring it to your ear to listen to the sound feedback emitted
by the handset during the programming phase.
2. Press the push button to be programmed and hold it down for at least 6 s.
3. When the entryphone has emitted a “beep” release the push button being programmed.
4. On push button entrance panels, press the call button for the entryphone, while entrance panels with alphanumeric
keypads, enter the call code and the call button to confirm ( or , depending on the entrance panel model).
5. A high tone confirms the end of the procedure. The entryphone will be called from the related entrance panel.
1 4 5
4 5
beep
beep
2 3
> 6 s
> 6s
beep
beep
2 3
To Next Page
Loading...
Need help?
General
