IT
27
40540 - 40542 - 40540.D - 40547
Programming the lock release button of a specific entrance panel (excluding the lock release
button)
1. In the case of a handset entryphone, raise the handset and bring it to your ear to listen to the sound feedback emitted
by the handset during the programming phase.
2. Press the push button to be programmed and hold it down for at least 6 s until the entryphone emits a first "beep"
followed by a double "beep".
3. Release the push button being programmed.
4. From the entrance panel involved, make a call to the indoor station being programmed (on push button entrance
panels, press the call button for the entryphone, while on entrance panels with alphanumeric keypads, enter the call
code and press the call button to confirm (
or , depending on the entrance panel model).
5. The entryphone receives the call and confirms that the push button has been programmed with a new “beep”.
1 4
4
beep
beep
2 3
> 6 s
> 6s
beep
beep
2 3
5
5
To Next Page
Loading...
Need help?
General
