IT
29
40540 - 40542 - 40540.D - 40547
Deleting all settings
This process is recommended when you want to change identification code is of a previously programmed
entryphone and you do not want to retain the operating programming of the device.
Programming phase (Simplified):
1. In the case of a handset entryphone, raise the handset and bring it to your ear to listen to the sound feedback emitted
by the handset during the programming phase.
2. Press and hold down the lock push button “
” for 6 s.
When the time runs out the indoor station will emit a “beep” (0.5 s).
3. Continue to hold down the door lock push button
After 2 s more the indoor station emits two “beeps” set apart (duration 0.5 s with a space in between).
4. Continue holding down the lock push button “
”.
After 2 s more the indoor station emits a continuous tone for 5 s
5. Release the lock push button “
”.
6. While the indoor station is still emitting a continuous tone, press the lock push button “
”.
7. Release and press the lock button “
”, three “beeps” will be emitted.
beep
1
beep
2 43 5
2 x beep
> 6 s + 2 s + 2 s
6 7
beep
3 x beep
To Next Page
Loading...
Need help?
General
