www.emachines.com
35
4 If you are removing a DIMM from the memory module
bank, gently pull the plastic tabs away from the sides of
the memory module and remove it.
- OR -
If you are adding a DIMM to an empty memory module
bank, gently pull the plastic tabs away from the sides of
the memory module bank.
5 Align the notches on the new DIMM with the notches on
the memory module bank and press the module firmly
into the bank. The tabs on the sides of the memory
module should secure the memory module
automatically. When the module is secure, you hear a
click.
6 Replace the side panel by following the instructions in
“Replacing the side panel” on page 33.
7 Return your computer to its upright position.
8 Reconnect the cables and the power cord.
9 Turn on your computer. Windows starts and the
Windows desktop appears.
10 Click Start, Control Panel, then click Performance and
Maintenance (if in Category view). Click System. The
amount of memory in your computer is shown at the
bottom of the System Properties dialog box in the
General tab.
8512635.book Page 35 Friday, July 27, 2007 11:21 AM
To Next Page
Loading...
