General failures’ analysis
GS35 – GS350 – MT350 – MT3500 chainsaws
d)
Engine seal test
•
Remove the parts as per the photo. Close off
the inlet port with the correct flange from the
tool kit (I
and II)
•
Close the exhaust port by putting the flange
between the muffler and cylinder III
(flange in
tool kit). Refit the muffle with the 3 screws M5x25
III
p/n 001000018
II
p/n 094500388A
IV
n°3 screws M5x25
Warning:
During the seal test use
only a light torque of
0,4 Kgm (35 in lb)
To Next Page
Loading...
