EMAK GS35 - Spark Plug Gap Check; Spark Test Procedure

General failures’ analysis
GS35 – GS350 – MT350 – MT3500 chainsaws
b) Spark plug inspection
Remove the spark plug and check the gap
between the electrodes (0,5 – 0,7 mm)
c) Spark test
• Fit the tester (I) between spark plug and spark
plug cap. Pull the rope and verify the current
• Replace the spark plug if necessary. Verify that the
spark plug thermal grade and type (resistive – R)
are correct
• Check that the spark plug pipe is correctly
connected, cables are not damaged and coil works
properly
(0,5 – 0,7 mm)
I
cod. 001000515R
RCJ-7Y