EMAK GS35 - Engine Tuning Procedures; Air Filter Cleaning and Replacement

General failures’ analysis
GS35 – GS350 – MT350 – MT3500 chainsaws
5) Tuning
a) Air filters inspection
b) Needle valve inspection
c) Carburetor inspection
d) Suggested tools for carburetion setting
e) Carburetor tuning
a) Air filters inspection
• Sponge air filter (A): clean with
Emak degreaser, rinse with
water and blast dry with
compressed air
• Cloth air filter (B): shake it and
clean it with a soft brush
• Replace the filter when damaged
Tightening torque
Support air filter-carburetor
0,4 Kgm (34,72 in lb)
+ Loctite 243
Tightening torque
Support air filter-insulator
0,2 Kgm (17,7 in lb)
+ Loctite 243
A
B