General failures’ analysis
GS35 – GS350 – MT350 – MT3500 chainsaws
d)
Flywheel-coil air gap inspection
•
Check the air gap using the shim (II-0,3 mm)
•
Adjust if not correct
II
p/n 001000004
Tightening torque coil-screws
0,4 kgm (34,72 in lb) + Loctite 243
e)
Flywheel key way inspection
•
Remove flywheel with corrector tool (III)
•
Inspect key way’s condition and position. If
necessary, replace or adjust
III
p/n 001000782
Tightening torque flywheel-nut
1,9 kgm (168,2 in lb)
Back to index
To Next Page
Loading...
