General failures’ analysis
GS35 – GS350 – MT350 – MT3500 chainsaws
Wind the spring 6
times. Verify that
the spring turns on
½ turn
ø 3,0 x 960 mm
a)
Check housing inspection
b)
Spark plug inspection
c)
Spark arrester test
d)
Flywheel-coil air gap inspection
e)
Flywheel key way inspection
3) Ignition system
a)
Starter housing inspection
Remove housing. Inspect parts for wear. If
necessary clean or replace
Important:
grease moving parts
Counterclockwise
turn
to release
the spring
Clockwise turn
to wind the
spring
Important: make sure the spring does not wind fully
with the rope fully out
To Next Page
Loading...
