General failures’ analysis
GS35 – GS350 – MT350 – MT3500 chainsaws
1) Rendimento
a)
Compression test
b)
Cylinder and piston inspection
c)
Cylinder and piston assembly
d)
Cooling system cleaning
e)
Muffler inspection
a)
Compression test
•
Apply the Emak compression
tester (I) on cylinder. Pull
energetically the rope 10 times
•
Verify that the compression
value in not less than 7,5 bar –
110 psi
•
If the value in higher than
7,5 bar –
110 psi, start
inspection d), if lower, carry on
with inspection b)
I
p/n 001000392A
To Next Page
Loading...
