CHAPTER 3. INSTALLATION 21
To disassemble the fence cover, the following sequence must be adopted
13
2.8. Fence cover disassembly
13
2.8
Fence cover disassembly
Step 1:
Using a screw driver, push
the keys in tabs of terminal
board cap.
Step 2:
Force the tabs on the
opposite direction (13) and
then move the cap up (14).
3.
Operation
Turning on your VNE
Features
Control models
Drop-in Frequency Serial
Compatible for mechanical
thermostat contact (on/off )
yes no no
Inverter decides the best speed yes no no
Thermostat decides the best
speed
no yes yes
Inverter send functional data
(power, voltage, failures)
no no yes
1
2
Application
3. Operation
3.1. Turning on your VNE
3.1.1. Application
Compatible for mechanical
thermostat contact (on/off)
Inverter decides the best speed
Thermostat decides the best
speed
Inverter send functional data
(power, voltage, failures)
Features
Yes No No
Yes No No
No Yes Yes
No No Yes
Crontrol models
Drop-in Frequency Serial
• Before obtain access to connectors, dis-
connect the AC power supply.
• Avoid contact of the Control Input Cable
(low voltage) with high voltage or power
supply cables, due to electrical hazard and
potential equipment damage.
• Please, before emplying the inverter with
compressor, refer to compressor technical
documentation not covered in the manual.
In case of doubt, please, contact Embraco
technical support.
To Next Page
Loading...
