GENERAL PRECAUTIONS
• During instalation the environment must be prop-
erly protected against ESD. The operator and ma-
chines must be properly Earthed.
• Make sure that Fullmotion CF10C Inverter will not
be in direct contact with ames during assembly.
• The location where the Inverter will be installed
must be protected against splashed water from all
directions.
• Do not open the Inverter enclosure. For installa-
tion, remove only the Inverter Cover to make the
electrical connections.
• This inverter is for use only with the Fullmotion Em-
braco compressors.
• Read this material carefully before you begin the
Fullmotion CF10C Inverter installation and start up
procedure.
• To prevent damage to your inverter during and af-
ter assembly, avoid contacting with the following
substances: Hydrocarbons; Ester based oils (e.g.:
compressor oil); Phenols; Amines; Ketenes; Au-
tomotive uids such as grease, except glycol and
heavy alcohol.
• The protection against access to live parts have
been evaluated according to the relevant require-
ments from IEC 60335-1 and UL 60730-1.
To Next Page
Loading...
