DPSI RV Family Operating Instructions Version 2.0
Page 42 of 48
Hint:
The limits for detecting low voltage of the algorism are designed especially for the
operation of RC flight models. When the DPSI RV is used for other applications,
it is possible that incorrect information may be given. If this is the case, the error
message (if it is perceived as disturbing) can be completely hidden (see
“Programming of batteries”).
8. Safety Instructions
In general, all connecting lines should be run so that they do not
come into contact with moving or hot parts of the model (such as
servos, gears or sound absorbers).
The DPSI RV must be protected from humidity and moisture.
The DPSI RV must be located at a sufficient distance from
neighboring surfaces to enable good heat dissipation of the heat
sink.
Improper handling of the DPSI RV can result in serious damage
to property or injury of persons!
Carry out a general inspection of all connections in your model
before each use! All plugs must be correctly polarized and have
clean contacts (i.e. fit tightly). Loose cables present a potential
hazard!
Under no circumstances may power sources being used that do
not meet the specified voltages.
The current-conducting contacts of the connector plugs may not
be short-circuited. If you fail to observe this warning, the short-
circuited cables may overheat and even melt.
The DPSI RV may not be taken apart or technically altered under
any circumstances.
Never use the DPSI RV for purposes other than for RC model
building as a hobby. Above all, their use in passenger-carrying
equipment is strictly prohibited.
Operate the DPSI RV only with the remote control components
provided for model making.
To Next Page
Loading...
