DPSI RV Family Operating Instructions Version 2.0
Page 30 of 48
If in doubt, it is reasonable and safer to detach the batteries from the
DPSI RV for charging. To do so, pull the plug from the holding clamps
of the DPSI RV in zigzag movements and slightly tilted to the side (not
applicable for DPSI 2001 RV).
Removing the battery plug from DPSI RV / RV Mini 5 (6):
Hint:
It is possible to charge the battery (e.g. via an additional charging cable
which is soldered on) if it is attached to a DPSI RV. Here, only one
battery must be charged rather than both at once (Exception: LiPo
batteries). Please observe correct polarity always!
5.8. Setting the Voltage
The output voltage of the DPSI RV can be set in 4 steps. This is done
using the provided jumper, which – depending on the output voltage -
is plugged to the coding strip of the DPSI RV. It is best to use tweezers
or a small pincer for this purpose. If the DPSI RV has been attached so
as to be free of oscillation, the jumper generally cannot fall out.
To Next Page
Loading...
