EMD Serono Easypod - Injection Depth; Injection Time

9
Section 1. Getting Started
Comfort settings
Injection depth – controls how deep the needle is inserted into your skin.
1. Open the “Comfort settings” menu (9a).
2. Use the “” key to highlight
“Injection depth” (9b).
3. Select “Change” to open the
“Injection depth” menu. The current
setting will be highlighted.
4. Use the “” key to select 4 mm, 6 mm,
8 mm, or 10 mm (8 mm and 10 mm
available for 29 G needles only) (9c).
5. Select “OK”.
Injection time – controls how long the needle stays in your skin.
1. Open the “Comfort settings” menu (9d).
2. Use the “” key to highlight
“Injection time” (9e).
3. Select “Change” to open
“Injection time”. The current setting
will be highlighted. Recommended
setting is 5 to 10 seconds.
4. Use the “OK” key to move the cursor
under the number you would like to
change and use the “” key to
change the number (9f).
5. When the correct number appears, select “OK” to move to the next number.
6. Select “OK”.
Menu
Dose history
Battery status
Comfort settings
Remove cartridge
Open Exit
Comfort settings
Needle speed
Injection speed
Injection depth
Injection time
Change Back
Injection depth
OK Cancel
4 mm
6 mm
8 mm (29G only)
10 mm (29G only)
Menu
Dose history
Battery status
Comfort settings
Remove cartridge
Open Exit
Comfort settings
Needle speed
Injection speed
Injection depth
Injection time
Change Back
Injection time
Choose between
+03 and +30 seconds
OK Back
+05 seconds
9a
9b
9c
9d
9e
9f