EMD Serono Easypod - By Body Surface; Check Settings

Section 1. Getting Started
Clinical settings
By body surface – dose per m
2
of body surface
1. Open the “Dose settings” menu and use the
“” key to highlight “By body surface” (17a).
2. Select “OK” to open the “By body surface” menu.
3. Select “OK” if the settings are correct, or select
“Change” to change the settings (17b).
4. Repeat steps 3 to 8 (under “Input in mg”, page 16).
Note: Posology (“Pos”) on (16f) and (17b) is another term used for “dosing” expressed as mg/kg/day
or mg/m
2
/day.
Check settings
This feature allows you to review the
Dose settings selected.
1. Use the “” key to highlight
“Check settings” from the
“Dose settings” menu (17c).
2. Select “OK” to open the “Current
settings (1)” menu, showing the
current Dose settings.
3. Select “Next” (17d) to open “Current
settings (2)”, showing the current Dose adjustment setting (17e).
4. Select “Back” to return to the “Dose settings” menu.
Dose settings
OK Back
Input in mg
By weight
By body surface
Check settings
By body surface
Dose:
Height:
Weight:
Pos:
Freq:
OK Change Back
17a
17b
Dose settings
OK Back
Input in mg
By weight
By body surface
Check settings
Current settings (1)
Dose:
Height
Weight:
Pos:
Freq:
Next Back
Current settings (2)
Prev Back
Dose adjustment:
Off
17c
17d
17e
17