EMD Serono Easypod - Date & Time

11
Section 1. Getting Started
Device settings
Date & Time
1. Open the “Device settings” menu (11a).
“Date & Time” will be highlighted.
2. Select “Change” to open the
“Date & Time” menu (11b).
3. To change the appearance of the date
and time, use the “” key to highlight
“Format” (11c).
4. Select “Change”.
5. Use the “” key to highlight “dd/mm/yy 24h”,
“mm/dd/yy am/pm” (US standard format),
or “yy/mm/dd 24h”.
6. Select “OK”.
7. To change the date, use the “” key to
highlight “Date” (11d).
8. Select “Change”.
9. Use the “OK” button to move the cursor under
the part of the date you would like to change,
and use the “” key to change the numbers (11e).
10. When the correct number appears, select “OK” to move to the next number.
11. Continue pressing “OK” until you return to the “Date & Time ” menu.
To change the time, use the “” key to highlight “Time”. Select “Change”. Use the same steps to
change the time as you used to change the date.
Note: Each time the batteries are removed, easypod will prompt you to change the date and time.
Menu
Battery status
Comfort settings
Remove cartridge
Device settings
Open Exit
Device settings
Date & Time
Sound
Name
Welcome picture
Change Back
Date & Time
Change Back
Date
Time
Format
11a
11b
11c
Date & Time
Change Back
Change date
OK Back
Date
Time
Format
07/04/00
11d
11e